The ultra-compact AXEON CRO-Series Reverse Osmosis System utilizes reverse osmosis technology and features a four stage prelter, membrane, and postlter design which is housed inside a single cartridge. A fth stage post-polishing inline carbon lter is installed between the tank and faucet for even better tasting water. The system includes a two gallon white storage tank, tubing, and quick connect ttings for a fast and easy installation. Stage 1 Stage 2 Stage 3 Stage 4 Stage 5 20 Micron Sediment Prelter GAC Prelter 50 GPD (189.3 LPD) Thin Film Composite Reverse Osmosis Membrane Post Carbon Filter In-line GAC Postlter
The Axeon CRO-50 Reverse Osmosis Water Filter System features a 4 stage RO membrane in a single cartridge with a post-polishing inline carbon filter. This cutting edge technology provides an ultra low waste-to-product ratio and can reduce water waste by 50%. The high flow membrane also ensures faster tank refilling. This system features a compact size for simple installation under your sink. No preliminary tank or unit assembly is required. The tank, faucet, feed and drain lines are pre-plumbed in the unit and factory tested. With only one main cartridge and one inline carbon filter, the CRO-50 RO System saves water, time, space, and money.
More Water to the Tank, Less Water to the Drain This single cartridge designed system takes advantage of cutting edge high ow membrane technology. In addition, a unique ow path gives the AXEON CRO-Series Reverse Osmosis System a superior waste-to-product ratio and can reduce water waste by 50%. The combination of the two means more water to the tank and less water to the drain. The high ow membrane also ensures faster tank relling. Compact and Lightweight The AXEON CRO-Series Reverse Osmosis System has been designed to take up less space under the sink. The complete system including the tank is approximately the same height and width of a standard system’s tank. The entire system is less than 14 inches in depth and can be lifted easily with one hand. The small footprint of this system makes it easier to install in cramped kitchen or bathroom cabinets
Saves Time and Money
With only one main cartridge and one inline carbon filter, the AXEON CRO-Series Reverse Osmosis System saves time when servicing and money on service calls and replacement cartridges.
Feed Water Requirements Pressure 40-80 psi (275 kPa – 552 kPa) Temp 40°F – 100°F (4°C – 38°C) TDS <1000 mg / L ppm Turbidity <1 NTU SDI <5 pH 4 – 8 Chlorine <1.0 mg/L Feed water must be potable, municipal water. Must be free of potential membrane foulants such as Iron, Hydrogen Sulfide and Manganese
Performance SpecificationsModel # CRO-50 Membrane Production 50 GPD (189.3 LPD) Waste to Product 1.67:1 TDS Reduction 96.5% Arsenic V Reduction 97.8% Cysts Reduction >99.99% Fluoride Reduction 96.3% Lead Reduction 98.0% Tested at 60 psig (4 bar), 500ppm TDS municipal water, 77°F (25°C)
DimensionsWidth: 9.72” W (24.7 cm)
Height: 15.38” H (39.1 cm)
Diameter: 13.75” D (34.9 cm)